Frequently Asked Questions

Time：2024-06-27Clicks：608

Phenomenon	Check content	Solution
Power switch indicator light off	Power on or not	Plug it in
Power switch indicator light off	Is the switch of the power supply position of the host on?	Power on
Indicator light screen not light	Indicator light of electronic board in main engine is off	Check whether the front and rear circuits of the switching power supply are on
		Check whether the switching power supply is burned out
		Check whether the power terminal of the electronic board is plugged in
	Electronic board indicator light on the main engine screen light off	Electronic board is bad, replace the electronic board
Host alarm	No rivet in vibrating disc silo	Add rivet to vibrating disc
	Rivet in vibrating disc	Whether there are special-shaped nails stuck in the vibrating disc track
	Push-pin clamp with shaped pull rivet	Take out the special-shaped rivet and then restore it
	Push-pin clamp with shaped pull rivet	Long press the K2 push cover to open automatically to the right, loosen the butterfly screw, remove the nail connector, and remove the studs
Main engine out of the nail but the nozzle is not nailed	Rivet tube bent or tied too tight	Loosen the binding or replace the rivet tube
Nail gun nozzle clamp	The nail enters the nozzle weakly	Nail cap diameter is not suitable, use a suitable nail
	The nail enters the nozzle weakly	Contact a professional to adjust atmospheric pressure or longer blowing time
	Pull nail into the nozzle too hard	Nail cap diameter is not suitable, use a suitable nail
	Pull nail into the nozzle too hard	Contact a professional to reduce the pressure or reduce the blowing time
	Nail skew, up or across the nail gun mouth	Tension spring fatigue, insufficient tension, can not make the gun mouth back
		Loose screws on top rod of nail gun causing parts to shift
		The screw of the lock cylinder of the nail gun is loose, resulting in the movable gun nozzle not on the same axis as the gun nozzle
Rivet not fit into nozzle	Nozzle hole blocked	Clear the nozzle hole or replace the nozzle
Put the nail into the nozzle and then spray out	The nail guide tube is blocked, causing air to blow out of the nozzle	Clear or replace the pull-out tube or Pu tube of the nail gun
No reaction from machine and nozzle	Trigger stuck	Lubricate trigger shaft position
No reaction from machine and nozzle	Sensor damage	Replacement of new sensor

Last：Can your nail puller be fully automated?

Next：What do we need to provide for custom fly-effect automatic nail puller?