Frequently Asked Questions
phenomenon | Check content | Solution |
The power switch indicator is off. | Is the power turned on? | Plug in the power |
Is the switch of the host plugged in the power position turned on? | Turn on the power switch | |
The indicator light is off. | The electronic board indicator in the main unit is not lit. | Check if the circuit before and after switching power supply is turned on |
Check if the switching power supply is burnt out | ||
Check if the power supply terminal of the electronic board is plugged in. | ||
The electronic board indicator light in the main unit does not light up. | Electronic board is broken, replace the electronic board | |
Host alarm | No rivet in the vibrating tray | Add the rivet to the vibration plate |
Rivets in the vibrating plate | Whether there is a special shaped nail in the vibrating disk track | |
Pusher card has shaped rivets | Remove the shaped rivet and restore it. | |
Long press the K2 push cover to open to the right automatically, loosen the butterfly screw, remove the nail connector, and clear the rivet | ||
The host is nailed but the gun is not nailed | The rivet tube is bent or deformed too tightly | Relax strapping or replace the rivet tube |
Pull the nail in the gun nozzle | Pull the nail into the mouth of the gun, weak and weak | Pull the nail cap is not suitable, use the appropriate pull stud |
Contact a professional to adjust the atmospheric pressure or lengthen the blowing time | ||
Pull the nail into the gun mouth too much force | Pull the nail cap is not suitable, use the appropriate pull stud | |
Contact a professional to adjust the air pressure or shorten the blowing time | ||
Pull the slash, top or cross over the nipper nozzle | The tension spring is fatigued, the pulling force is insufficient, and the gun head cannot be returned to the front. | |
The screw on the ejector pin is loose, causing the part to shift | ||
The rivet gun lock cylinder screw is loose, causing the movable nozzle and the nozzle to not be on the same axis | ||
Pull rivet does not fit into the nozzle | The mouth of the gun is blocked | Clear the mouth of the gun or change the nozzle |
After being nailed into the nozzle, it is ejected | The guide tube is blocked, causing the air to blow out of the nozzle | Clear or replace the nail removal tube or Pu tube of the rivet gun |
The machine and the gun mouth did not respond | Trigger stuck | Trigger movable shaft position lubrication |
Sensor damage | Sensor damage |
Last article:Can your nail puller be fully automated?
Next article:What do we need to provide for our custom fly-effect automat
-
Add: Hongfu Science Park, Xiaban Village, Houjie Town, Dongguan City
400:4006-784-785
TEL:0769-89874163
Mob:150 1677 5153
E-mail:xunjiezdh@126.com